Spark Plug Socket for 2 and 4-Stroke Engines
- SKU:
- ENGMI-SPK
- Weight:
- 0.10 LBS
Spark plug socket tool for use in removing spark plugs from your motorized bicycle.
Related Products
Clutch Key for 4-Stroke Engine
Key for 5/8" shaft centrifugal clutches.
Muffler Bolts for 4-Stroke Engine
After market bolts to attach a muffler to a 4 stroke engine. Set of 2. Bolt Size: M5x17x20 8mm Hex Head
4-Stroke Spark Plug
4 Stroke Engine Replacement Part # 68 -- Spark Plug
4 Stroke Engine Crankshaft
Also includes Gear Wheel (Part #14) and 6203-P5 Bearing (Part #21) 4 Stroke Engine Replacement Part # 25 -- Crank Case
2-Stroke Spark Plug For Zeda 80 Engine
1) Spark Plug
Customers Also Viewed
Spark Plug Wire Terminal Cap
Replacement terminal cap for CDI Item #ENG2S66-CDI
4-Stroke Spark Plug
4 Stroke Engine Replacement Part # 68 -- Spark Plug
Spacer Set of 4
Spacer Set includes 4mm, 7mm, 9mm, and 12mm spacers. These are used to adjust all pulleys.
Solid Thread for HD Axle 6 Hole
Allows for Brake rotor to be installed on wheel assemblies.
Spacer For 10 Tooth Drive Sprocket
The spacer allows a proper adjustment and alignment with the Transmission chain sprocket and the rear wheel sprocket. These are often combined with Item# ENG4GT-NTSDS.
2-Stroke Spark Plug For Zeda 80 Engine
1) Spark Plug
Snap Ring for Wrist Pin - Set of 2
4 Stroke Engine Replacement Part # 29 -- Snap Right for Wrist Pin (set of 2)
Snap Ring 16mm, 32mm, and 35mm Diameter
Snap ring or bearing retainer clip that holds bearings in place for 16mm, 32mm and 35mm diameter bearings.
Spacer-ENGMI-SPCR201518
OD: 20mm, ID: 15mm, Thickness: 18mm
Thick Clutch Side Rubber Bearing Seal (Part #6)
6) Thick Clutch Side Rubber Bearing Seal (set of 2)
Small Spacer Kit for 4G Transmission
ID: 17mm OD: 21mm and thickness 2mm and 6mm
Small Clutch Lever Spring (Part # 33)
The Clutch Lever Spring slides onto the end of the clutch cable to allow maximum release when the clutch lever has been disengaged.